Hi, I have been trying to reproduce TurekHron FSI benchmarking results. It involves a parabolic inlet condition. And FSI simulation works fine for Re = 20, but gives the following error for Re=100. [th100] I am using OpenFOAM and CalculiX for the FSI simulation coupled with preCICE. I have at…

Hello @Makis , @uekerman I finally figured it out. [Screenshot from 2020-01-12 21-57-13] It’s stable. The y-displacement plot of the tip is as shown which properly aligns with the paper with a minor error. Thanks for all the help. It was difficult to replicate the paper as a lot of forum discus…

Divergent FSI simulation with Reynold's number = 100 and above

Official adapters and tutorials

nithinadidela January 25, 2020, 2:02pm 11

Hey @uekerman

Sorry for the delay.
I finally found time and opened a PR in the tutorials repository. I think I did it right. I am new to this. So, it’d be great if you can inform me if I messed up something.

Thank you.

Turek-Hron FSI with OpenFOAM and CalculiX

Topic		Replies	Views
Turek-Hron FSI with OpenFOAM and CalculiX Official adapters and tutorials openfoam , calculix , fsi	21	2822	November 12, 2022
Turek benchmark FSI3 benchmark problem: Large displacement deviation Using preCICE openfoam , calculix , fsi	6	369	December 30, 2023
OpenFOAM-CalculiX FSI Diverging Sim Never Ends Using preCICE openfoam , calculix , fsi	21	2741	September 10, 2021
FSI coupling problem between Openfoam and Calculix: the 3D flexible plate Using preCICE openfoam , calculix , fsi	8	104	August 29, 2024
Growing Courant number in OpenFOAM FSI simulation Using preCICE openfoam , calculix , fsi	7	857	February 17, 2022

Divergent FSI simulation with Reynold's number = 100 and above

Related topics