Hello all, I was simulating the turek fsi3 and I tried to change some of the boundary conditions for my simulation. Well the limit cycle didn’t reach for the end time 7.5 seconds. I wanted to restart the calculation from the last timestep. Is there any way to do this since I was able to restart the…

Hi @daniel the short answer: with our provided deal.II codes, you can’t do this (though I’m not sure which post you are referencing here). In general, preCICE can do this (although the acceleration matrices will not be the same). I never felt like there is urgent need to support a restart with our …

How can I restart a coupled OpenFOAM-deal.II simulation from last iteration

Official adapters and tutorials

Makis August 6, 2021, 1:07pm 3

The post from our FAQ mentioned above: How can I restart a coupled simulation?

Topic		Replies	Views
Instability after restart in coupled FSI simulation (OpenFOAM / CalculiX / preCICE) Official adapters and tutorials openfoam , calculix , fsi	2	121	January 19, 2026
Restarting a coupled FSI simulation involving OpenFOAM in PARALLEL Official adapters and tutorials openfoam , adapters , fsi	2	471	December 3, 2021
Restarting coupled FSI simulation with preCICE Using preCICE openfoam , configuration , faq , calculix	10	2361	July 3, 2024
Restart after stopping calculation Using preCICE openfoam , calculix , restart	1	1111	October 29, 2019
A question about official examples of Openfoam and Dealii calculations Official adapters and tutorials openfoam , adapters , dealii	2	153	January 31, 2024

How can I restart a coupled OpenFOAM-deal.II simulation from last iteration

Related topics