Hi everyone, I’m currently simulating a FSI problem using OpenFOAM_7 + Calculix_2.16 and preCICE_v2.0.0. The below gif. shows that there is a node on the back side which seems to be fixed and not moving as other nodes did. [20210316_223548] My question is that whether this issue is caused by da…

Hi, I have resolved this posted issue by switching from CalculiX v2.16 Multi-Thread version to CalculiX v2.15 normal version. The fixed node is now moving properly! Don’t know what exactly caused this issue but switching from v2.16 to v2.15 should be a solution to this problem. Zs

CalculiX single node stagnation problem

Non-preCICE

DavidSCN March 17, 2021, 7:05am 2

Hi @djmeee
have you already seen this related post? It seems to be very similar to your problem description.

Best regards,
David

Topic		Replies	Views
Sticking nodes on FSI interface in OpenFOAM/CalculiX coupling Official adapters and tutorials openfoam , calculix , fsi	9	1515	March 25, 2021
Calculix-OpenFOAM coupling strange behaviour Using preCICE	1	263	June 19, 2023
Temperature anomaly/ Calculix OpenFoam CHT Coupling Official adapters and tutorials openfoam , calculix , cht	7	631	February 16, 2022
Perpendicular - flap case display problems Official adapters and tutorials openfoam , adapters , calculix	2	262	September 14, 2022
Understanding dataflow - Calculix to OpenFOAM Using preCICE openfoam , calculix	3	388	October 30, 2020

CalculiX single node stagnation problem

Related topics