************************************************************ CalculiX Version 2.15, Copyright(C) 1998-2018 Guido Dhondt CalculiX comes with ABSOLUTELY NO WARRANTY. This is free software, and you are welcome to redistribute it under certain conditions, see gpl.htm ************************************************************ You are using an executable made on Sa 15. Dez 15:34:34 CET 2018 Decascading the MPC's Determining the structure of the matrix: number of equations 240 number of nonzero lower triangular matrix elements 3128 Starting FSI analysis via preCICE using the geometrically non-linear CalculiX solver... Using up to 1 cpu(s) for the stress calculation. Using up to 1 cpu(s) for the symmetric stiffness/mass contributions. Factoring the system of equations using the symmetric spooles solver Using 1 cpu for spooles. Using up to 1 cpu(s) for the stress calculation. About to enter preCICE setup in Calculix with names Calculix and config.yml Setting up preCICE participant Calculix, using config file: config.yml ---[precice]  This is preCICE version 2.0.2 ---[precice]  Revision info: no-info [Git failed/Not a repository] ---[precice]  Configuring preCICE with configuration: "./precice-config.xml" Set ID Found Read data 'Forces0' found. ---[precice] ERROR:  There is no Mesh with ID:-1 The numbers below are estimated upper bounds number of: nodes: 126 elements: 40 one-dimensional elements: 0 two-dimensional elements: 0 integration points per element: 27 degrees of freedom per node: 3 layers per element: 1 distributed facial loads: 0 distributed volumetric loads: 0 concentrated loads: 258 single point constraints: 396 multiple point constraints: 1 terms in all multiple point constraints: 1 tie constraints: 0 dependent nodes tied by cyclic constraints: 0 dependent nodes in pre-tension constraints: 0 sets: 4 terms in all sets: 384 materials: 1 constants per material and temperature: 2 temperature points per material: 1 plastic data points per material: 0 orientations: 0 amplitudes: 3 data points in all amplitudes: 3 print requests: 0 transformations: 0 property cards: 0 *INFO reading *STEP: nonlinear geometric effects are turned on STEP 1 Dynamic analysis was selected Newton-Raphson iterative procedure is active Nonlinear geometric effects are taken into account