# The perpendicular-flap model using OpenFoam

**URL:** <https://precice.discourse.group/t/the-perpendicular-flap-model-using-openfoam/1695>\
**Category:** Using preCICE\
**Tags:** openfoam, fsi\
**Created:** [December 1, 2023, 5:43am UTC](https://precice.discourse.group/t/the-perpendicular-flap-model-using-openfoam/1695 "2023-12-01T05:43:36Z")\
**Posts on this page:** 1\
**Showing post:** 15

<div class="post-metadata">

**Author:** ![FelixR](https://avatars.discourse-cdn.com/v4/letter/f/b19c9b/32.png) [@FelixR](https://precice.discourse.group/u/FelixR)\
**Post date:** [December 11, 2023, 5:54pm UTC](https://precice.discourse.group/t/the-perpendicular-flap-model-using-openfoam/1695/15 "2023-12-11T17:54:12Z")

</div>

> It appears the openFoam mesh/nodes is/are very coarse. There are only 33 nodes in openFoam VS the 494 solid nodes

From this thread I learned that for a conversative mapping the fluid mesh should be finer than the solid mesh, otherwise it leads to instabilities: [Spatial oscillations occur when using conservative interpolation from coarse to fine mesh](https://precice.discourse.group/t/spatial-oscillations-occur-when-using-conservative-interpolation-from-coarse-to-fine-mesh/510)

Did you try to make the fluid mesh finer?

---

_[View the full topic](https://precice.discourse.group/t/the-perpendicular-flap-model-using-openfoam/1695)._
